Devil Skull Pin, Pewter

The devil skull
The devil’s skull, jaw wide open and forehead carved with tribal patterns, and two large curled ram’s horns on either side. A wide, menacing pin that gets noticed on a vest. The pin is 11 mm (0.43 in) thick at the centre, with flat edges that sit flush on the leather.

Two attachment points
At 52 mm (2.05 in) wide and 35 mm (1.38 in) high, this pin sits on two posts: it stays firmly in place on your vest. To make sure you never lose it on the road, try our locking pin backs (you’ll need two).

Handmade, piece by piece
In our family workshop, since 1989, every pin is cast in solid pewter in our own moulds, deburred by hand and given an aged silver patina. The patina brings out every detail of the relief, and pewter never rusts. And it looks even better in real life than in the photo: the relief and patina really show once it’s in your hand.

Technical specifications:

• Attachment points: 2 posts on the back, supplied with butterfly clutches
• Width: 52 mm (2.05 in)
• Height: 35 mm (1.38 in)
• Weight: 18.5 g (0.65 oz)
• Thickness: 11 mm (0.43 in) at the centre, flat edges
• Maximum fixing thickness: 2 mm (0.08 in) with butterfly clutches, 3 mm (0.12 in) with our locking pin backs
• Finish: hand-applied aged silver patina
• Material: solid French pewter
• Made: in our workshop in France