Crossed Revolvers Pin, Pewter

Crossed revolvers are a great classic of Western imagery. They recall the American West and its outlaws, men who lived by their own rules and knew how to stand up for themselves. On a biker vest, they carry the same spirit: independent, and never one to back down.

Real relief
Both revolvers are sculpted in full volume, up to 5 mm thick at the centre, with their cylinders, hammers, trigger guards and checkered grips. The edges taper down until they blend into the surface, so the pin sits flat against the leather, with no sharp edge sticking out or catching.

Two fastening posts
At 40 mm wide, this pin is held by two posts: it stays straight and won’t spin on your vest. To make sure you never lose it on the road, try our locking pin backs (you’ll need two), which fit all our pins.

Handmade, piece by piece
In our family workshop, since 1989, each pin is cast in solid pewter in our own moulds, deburred by hand, then patinated to give it the antique silver look that brings out every detail. No two are exactly alike.

In real life
Our photos already show the difference in finish compared with mass-produced pins. But they can’t convey the true relief or the weight of solid pewter: in your hand, the pin feels more substantial and looks even better than on screen.

Technical details:

• Origin: made in France, in our workshop
• Material: solid French pewter
• Finish: hand-applied antique silver patina
• Width: 40 mm
• Height: 28 mm
• Thickness: 5 mm at the centre, tapered edges
• Weight: 9.5 g
• Fastening: 2 posts on the back, supplied with butterfly clutches
• Maximum fastening thickness: 2 mm with the butterfly clutches, 3 mm with our locking pin backs